Series 90007 16A Terminal Blocks - Screw / Screwless

The Metway MA-CANPIR passive infra red detector is an addressable sensor for use with the MA addressable range of LCM's and gateways. It detects movement using a PIR sensor, which updates the light controller using a CAN bus interface.

Daylight linking can be configured either to keep lights off when there is sufficient ambient light, or used as part of a closed loop to maintain a pre-set luminance level in a dimmable system.

Connection is made by RJ12 connectors on the back of the unit, there are two of these to allow easy onward connection.

Series 900Q 16A Terminal Block screw/screwless

The Metway MA-DALIPIR passive infra red detector is an addressable sensor for use with the MA addressable range of LCM's and gateways. It detects movement using a PIR sensor, which updates the light controller using a DALI interface.

Daylight linking can be configured either to keep lights off when there is sufficient ambient light, or used as part of a closed loop to maintain a pre-set luminance level in a dimmable system.

The walk-test mode, indicated by a built-in LED, helps when configuring the detector. The MA-DALIPIR is connected via a screw terminal on the rear in a standard DALI two wire configuration, powered from the data line.

980 Series 3 Pole Screwless T'block

Series 162 6 way distribution blocks

Our Metway fully addressable leads are supplied with a 6-pole side latching plug, to a free end using 1.00mm² LS0H cable. This can be supplied in a variety of cores, and lengths as per your requirements.

These are supplied with a black/blue industry standard, connector coding. These leads will connect to the two fully addressable lcm's MA-DD1LCM10/M and also MA-DS10LCM10-S5.

Series 162 LED Grey

Our classic latching lead, can be used in a variety of LCM's (For example: Phillips Dynalite). They are supplied with a 6-pole centre latching plug, to a free end using 1.00mm² LS0H cable. This can be supplied in a variety of cores, and lengths as per your requirements.

These are supplied with a black/blue industry standard, connector coding. Alternatively there is an option for black/grey connectors.

Series 162STS 2 pole “maxi” low voltage connectors

Our classic non-latching box lead, can be used in a variety of LCM's (For example: Delmatic, Ex-Or). They are supplied with a 6-pole centre latching plug, to a free end using 1.00mm² LS0H cable. This can be supplied in a variety of cores, and lengths as per your requirements.

These are supplied with a black/grey industry standard, connector coding. Alternatively there is an option for black/blue connectors.

Series 503SI Fused terminal blocks - 20mm x 5mm fuses