- New
MPROG
The MPROG is a compact infrared handset used for the basic programming of IR enabled Metway products.
Pointing the handset
You must point the handset directly at the device that you want to control or program. When programming a device it is only necessary to point the handset when ‘sending’ a new setting.
Sending settings to a device
To send the programming parameters to the device, it is simply a case of pressing the relevant button for the setting you require. If the setting is in red type, you would press the 'Shift' button (this handset will display a red light to denote this) and then press the setting you require.
Approvals
Request STP/BIM File
- You can change the sensor parameters from presence to absence.
- Detections times can be configured from a 2s test to 30 mins.
- An additional stand-by time can be programmed to extend detection times.
- Ability to change the daylight threshold before sensors activate.
- Ability to change dimming levels on DALI detectors (PIRDA or MWDD only).
Compatibility
PIRSW Metway Broadcast Switching Sensor.
PIRDA Metway Broadcast DALI Sensor.
MMSW Metway Broadcast Switching Microwave.
MWDD Metway Broadcast DALI Microwave.
Specific References
Array
The MPROG is a compact infrared handset used for the basic programming of IR enabled Metway products.
Pointing the handset
You must point the handset directly at the device that you want to control or program. When programming a device it is only necessary to point the handset when ‘sending’ a new setting.
Sending settings to a device
To send the programming parameters to the device, it is simply a case of pressing the relevant button for the setting you require. If the setting is in red type, you would press the 'Shift' button (this handset will display a red light to denote this) and then press the setting you require.